BBow
Mechanical
- Oct 5, 2015
- 28
Is there a way, or code somebody already has to select bundles for different mach's inside of NX?
We have limited amount of mach 3 bundles, so our tool makers on the floor have had them taken away, but now they cannot use NX to pull part weights. We would like to be able to get an NXOpen program to run that would:
1. Select a Mach 3 bundle
2. Run a 'measure bodies'
3. Do a 'select all' in the NX window
4. Read the 'mass', and output to a listing window
5. Close the 'measure bodies' dialogue
6. Unselect the mach 3 bundle
We have limited amount of mach 3 bundles, so our tool makers on the floor have had them taken away, but now they cannot use NX to pull part weights. We would like to be able to get an NXOpen program to run that would:
1. Select a Mach 3 bundle
2. Run a 'measure bodies'
3. Do a 'select all' in the NX window
4. Read the 'mass', and output to a listing window
5. Close the 'measure bodies' dialogue
6. Unselect the mach 3 bundle