Selected Assemblies aren't Highlighting

[EricFischer]

When I select an assembly in any other .sldasm file, it highlights. When I select an assembly in this one, it does not. See attachment. Thoughts? Help?

Note: These assemblies are part of larger assemblies that do highlight (i.e. - 101 highlights, while 110 does not), but I've had this type of setup highlight before no problem.

 

[ZillionM]

Maybe a save as on the assembly would do it. There arent many options in e-drawings so my guess is its the file who's causing the trouble.
Im not sure if e-drawings imports any options from the assembly. If so, the difference could lie in SW options (template)

 

[ArtemTat]

Make sure that the problematic sub-assembly is visible from this point of view. I mean probably this assembly is a bit small(something like small fastener) and you just don't take a notice on it.

Artem Taturevich
CSWP