set default for NX3 fly-out tabs to "pinned"?

[abeschneider]

I find that I always have to "pin" the fly-out tabs (ie Part Navigator, Assembly Navigator, CAST, etc) after launching NX3.

Does anyone know how to set the default so that the tabbed windows are always "pinned" upon launching NX3?

Thanks!

 

[UGperson]

adeschneider,

Dubble click on the part or assembly navigator icon and it should be permently docked.

Jeremy

 

[abeschneider]

Thanks; that works , kind of (the window breaks out of the tab bar and then I can dock it inside the graphic window or snap to an edge of the window...) but is it possible to actually just set the tab bar itself to be pinned open (rather than pulling the particular browser out of the tabbed form)?

Again, thanks; even if there isn't a way to do what I'm describing, your method is a good alternative.