set surface contact type " Bonded " in patran

[Charoenpon555]

Hi, Everyone
I have a question that
How to set surface contact type " Bonded " (as in Ansys) in patran ?

Could anyone guide me please.

Thank in advance

Best Regard, Charoenpon555

 

[TxAg78]

You didn't say which solver (Preference) you are using.
Assuming it's Nastran or Marc, you should look create "Glued Contact". Define deformable contact bodies (under Loads), then set as "Glued" in the Contact Table in Analysis setup. Contact Table found under "Subcases", "Subcase Parameters" for Nastran Pref.