Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

setting up a hp deskjet to nx

Status
Not open for further replies.

keddano

Automotive
Oct 28, 2005
10
US
Trying to get a HP deskjet 9659 inkjet plotter working with nx2.Think I'm having problem with the correct plotter switches setting. here's my current settings in order on Pqmgr:
Despooler name =UGIIHP
Plotter Vendor =Hewlett-Packard
Plotter Type =Electrostatic
Number of pens =8
Controller ID =
Plotter Model =9659
Plotter Switches =/AR/AS/17/MO/BS=0.0x0.0
Media Control =Continuous
Distance between Plot =0
Output Mode =Queue
Plotter Com Line =
System Queue Name =\\nickel-serv\hp9650
Directory Pathname =
Tape Density =1600
Message Interval =
Message Com Line =
Horizonal Maximun =0
Vertical Maximum =0
Steps per Inch =1420
Optimization Level =None
Thanks in advance for any help,Dan



















 
Replies continue below

Recommended for you

Most Deskjets only support PCL. UG only supports HPGL or HPGL2.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
Sr IS Technologist
L-3 Communications
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top