I am a machinery reliability engineer. I am developing a standard for shaft repair. I want to define what sorts of damage to certain areas can be repaired using HVOF, Flame Spray (metalizing), Sleeving, Welding, Belzona, etc. I want to take into account the service conditions of the shaft: wearing area under pump packing, areas under interference fit parts such as impellers, ball bearings or coupling hubs, bearing journals in sleeve bearings, etc. Is anyone aware of existing standards that might be helpful?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Shaft Repair Standard 1
- Thread starter JJPellin
- Start date
The Classification Bureaux have a great deal of knowledge with regard to all types of shaft repair, propeller shafts being a typical area for example. Try Marcus Cridland at ABS London, E-mail 'mcridland@eagle.org'. Other CBs are Lloyds Register, DnV, Bureau Veritas, and so on,
Regards,
Graham Tyler
Regards,
Graham Tyler
-
1
- #3
- Status
Similar threads
- Locked
- Question
- Locked
- Question