Siemens Sinumerik Post Builder Controller Change Help

[Buckshott00]

I'm using the UG Siemens PostBuilder, and when I started making a 2 axis Lathe Post, I picked the Controller as a Sinumerik 840D Lathe. What I found out today was the controller is actually a Fanuc controller.

Is there anyway to easily changed this over? Or to change the nurbs so it runs correctly?

Thanks,
--BuckShott00

 

[markrief]

I recommend you start over, and select a Fanuc controller when you create the post.

Mark Rief
Product Manager
Siemens PLM

 

[wmalan]

As Mark said, just start over. That said just open the current one and the new one with the proper control side-by-side. Makes it easy to re-populate all the information. You are not the first to have to do this... and won't be the last. It goes pretty fast that way.

--
Bill

 

[Buckshott00]

Thanks you two. I'm new to post-writing, and it took me a while to get this one "right" so to get all the way done and find out that I messed up one of the fundamental pieces was pretty hard to swallow.