Konstruktor
Mechanical
This should be easy and not questioned here, but... How in IV(11) simple (extruded) cut can be done so, that both sides are keeped? Or you can't do this?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Simple cut?!
- Thread starter Konstruktor
- Start date
- Status
aardvarkdw
Mechanical
Both sides are kept? What do you mean? What are you trying to accomplish?
- Thread starter
- #3
Konstruktor
Mechanical
First I would use this possibility to create multibodys - like I did with SolidWorks 
. Another reason to use it is, for example, instead of using corner rip. (When I suddenly need a flat pattern from sheet metal box with closed corners...)
. Another reason to use it is, for example, instead of using corner rip. (When I suddenly need a flat pattern from sheet metal box with closed corners...)- Status
Similar threads
- Locked
- Question