Simulate a roller suport

[FF12345]

Hi,

Anyone can help me how can I simulate a roller suport over a Shell (bearing Wall)?

Thanks.

 

[RK Sriwastav]

There is an option (in joint restraints) where you can directly apply roller at selected multiple points in SAP2000.

Ravi K

 

[JoshPlumSE]

Typically done using a member end release for the member that frames into the wall. If the member comes in at an odd angle, you can always create a little link member and manipulate the link member's orientation so that it's end releases can get you the restraint you're looking for.

 

[JasonMcKee71]

You can divide the wall into multiple elements and apply the restrained on the generated nodes.

Jason McKee
proud R&D Manager of
Cross Section Analysis & Design
Software for the structural design of cross sections
Moment Curvature Analysis
Interaction Diagrams
Reinforcement Design etc.