JHB1125
Aerospace
- Jul 22, 2011
- 1
Hello all,
New to the forum and solidworks.
I have designed a drop-gag for a driveline shaft assembly. the system sees a torque of 100Nm and we need this "drop gag to drop into place to stop the shaft from turning.
I have attached the image of the whole assembly and also a PNG of the milled coupling and drop gag piece.
As I have not yet completed my simulation training I am struggling a little with getting some results to see if this component is upto the forces and torques.
couple anyone help me? Much appreciated in advance.
Regards,
J
New to the forum and solidworks.
I have designed a drop-gag for a driveline shaft assembly. the system sees a torque of 100Nm and we need this "drop gag to drop into place to stop the shaft from turning.
I have attached the image of the whole assembly and also a PNG of the milled coupling and drop gag piece.
As I have not yet completed my simulation training I am struggling a little with getting some results to see if this component is upto the forces and torques.
couple anyone help me? Much appreciated in advance.
Regards,
J