Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Sine sweep analysis

Status
Not open for further replies.

dankoonFANTOMAS

Aerospace
Jun 1, 2016
31
Dear all,

I want to perform a sine sweep analysis on an assembly and I wanted to be sure that the *STEADY STATE DYNAMIC was the good method for this. Can anyone tell me that's good?

I have another question, I want to make a restart from a modal anaylsis but every time wy analysis failed, it is possible to make a restart with all the procedure on abq or are there restrictions?

Regards
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor