Sketch entities in drawings

[snaper]

Feel I may have toggled something on or off in either document properties or system options.

Experimenting with some drawing settings yesterday. Now I am no longer able to snap a line to the mid point of a part in a drawing. If this is any help a dialog box pops up which reads,

Please select entities from the same drawing view

Thanks in advance for your help.

 

[cygnas]

Click on the following:

Tools
Options
Document Properties
Grid/Snap
Snap

Here you can make sure you have the options check-marked that you need.

Hope this is what you were looking for.

 

[MElam]

It sounds like your sketched line is not associated with the view the part is in.

Right-click the view and "Lock view focus". Then draw your sketch and you should be able to tie it to the part.

 

[snaper]

Both options worked.

Thank You