I'm using NX9 and in some cases when I am constraing a Sketch
it will tell me that the Sketch needs 0 contraints, but in the Part Navigator
it still tells me that the Sketch in undercontrained.
Why, and does this mean that my Sketch is actually Fully constrained.
What am I missing.
Thanks,
Timey
it will tell me that the Sketch needs 0 contraints, but in the Part Navigator
it still tells me that the Sketch in undercontrained.
Why, and does this mean that my Sketch is actually Fully constrained.
What am I missing.
Thanks,
Timey