Sketch Tracing in SW2010? 1

[PhoenixDynamometer]

Hello all,
I have a sketch picture that I would like to trace over and I thought there was someway in SW to trace in the sketch mode. I have tried a rastor to vector conversion but I would prefer to trace it if possible. Suggestions welcome.

Regards,
PD

http://www.phoenixdyno.com

Home of the world's most accurate and repeatable dynamometers, dynamometer accessories, and data acquisition & control software.

 

[CorBlimeyLimey]

Auto Trace;

http://help.solidworks.com/2011/Eng...acyhelp/sldworks/sw_sketch/sketch_picture.htm

Or just insert the image into a sketch, size to suit, and use the regular sketch functions to trace manually.

 

[PhoenixDynamometer]

Hi CBL,
Looks like the "Auto Trace" function is not available in 2010 as I do not have the "2nd page" on the sketch picture property manager. Thanks for your input.

PD

http://www.phoenixdyno.com

Home of the world's most accurate and repeatable dynamometers, dynamometer accessories, and data acquisition & control software.

 

[DiegoLGraves]

PD, check tools, addins for Autotrace

regards, Diego

 

[PhoenixDynamometer]

Hi Diego,
You are correct, THANK YOU!

http://www.phoenixdyno.com

Home of the world's most accurate and repeatable dynamometers, dynamometer accessories, and data acquisition & control software.