Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Sketcher Dimensions 4
- Thread starter jme
- Start date
Hmmm... I found one here for the config.pro... font_size... it is used to determine the relative size of text in menus and diolog boxes...
that can't be it... Might be though... I'll have to try it later... Nothing else seems to match... I'll get back to this if no one else does... Daniel Pro/E Specialist
that can't be it... Might be though... I'll have to try it later... Nothing else seems to match... I'll get back to this if no one else does... Daniel Pro/E Specialist
-
4
- #3
in config.pro
text_height_factor set it to 30. The bigger the number the SMALLER the text. 20 is LARGE, 60 is small.
Not documented but works well. Increases text size for all dimensions as well as text like SIMP REP that appears on your screen when setting a new rep. You must exit Pro/E and restart for it to take effect.
text_height_factor set it to 30. The bigger the number the SMALLER the text. 20 is LARGE, 60 is small.
Not documented but works well. Increases text size for all dimensions as well as text like SIMP REP that appears on your screen when setting a new rep. You must exit Pro/E and restart for it to take effect.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question