Sketcher options 1

[SofiaB]

Hello everyone!

So I'm doing an analysis on a big truss and to draw the welds I'm using the sketch option to partition the faces. That was until this warning appeared:

Warning: The limit for coplanar entities has been exceeded; therefore,
no entities will be automatically projected onto this sketch.
Use the sketch project tools to manually project edges onto this sketch.

After that, I went to the sketch option to try and increase the max coplanar entities to project(for example to the double) but it didn't let me. I will leave images to better express my problem.

Thank you so much for all the help, very much needed!

 

[Mustaine3]

Try doing what the message says. Remove the Auto option at the sheet size and set it to 1e4 or lower.

 

[SofiaB]

The problem is that when I input a number lower than 1e4 for example, 600, that message appears.

 

[Mustaine3]

Do you enter that number in the max coplanar option or in the sheet size option? Read my previous message carefully again.