Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Slot position

Status
Not open for further replies.

shaneg

Mechanical
May 29, 2010
2
I have a customers drawing that has a slot with no locational tolerance. But, has a centerline thru the center of it. Is there a default position tolerance in this case.
 
Replies continue below

Recommended for you

Assuming ASME Y14.5M-1994 or equivalent (and assuming no notes about perfect alignment/symmetry at MMC etc.) then no there is not a default position tolerance and the drawing is lacking information.

See section 2.7.3 the std.

Posting guidelines faq731-376 (probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor