Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Small pressure driven generator

Status
Not open for further replies.

guilio2010

Electrical
Nov 8, 2012
80
A few years ago I remember seeing a small device that produces power from gas pressure. It wasn't any large, but it pulled gsa from I want to say 1/4" line and then after the drop, you would send it back into the gas stream of higher pressure. Anyone seen this before?
 
Replies continue below

Recommended for you

No, not a typo. It took a fraction of a gas stream, moved a turbine (pressure drop) and combined it back to another gas stream of higher pressure. If I remember the brouchure, it said something that it has minimal effect of the pressure downstream since it wasn't using enough gas compared the other stream to drop the pressure that much. If I remember, this was something on the order of 10W?!?!

Like I said, this was a few years back when I read this and I thought I still has the paper but just wanted to see if anyone else heard of it.
 
I wonder if the gas was reintroduced through a venturi arrangement.

Bill
--------------------
"Why not the best?"
Jimmy Carter
 
Compressed air turbine is close. I don't see a picture of something that looks like it is manufactured but I'll keep looking.

Thank you!
 
We have used pneumatic-driven lighting for work inside vessels. The air supply was from an engine-driven compressor. The lighting units are commercially available.

old field guy
 
"it pulled gsa from I want to say 1/4" line and then after the drop, you would send it back into the gas stream of higher pressure"
That, if anything, would be the perfect overunity Dream.

Gunnar Englund
--------------------------------------
Half full - Half empty? I don't mind. It's what in it that counts.
 
Pull out high pressure gas, extract energy from it, re-inject at the same pressure? Sounds like perpetual motion to me.
 
Found it guys. It's from PGI. It's called a Zeus Pipeline Power.

I haven't seen much of it or any installed or even if this was a wild concept that was brought up but not working but anyhow there it is.
 
From the manual:
The TEC - 8 consumes a small amount of fuel
(3.0 CFH for N.G. and 1.0 CFH for Propane Gas )
in a flameless oxidizing catalyst to heat the hot side of
an array of Peltier thermoelectric modules.

Bill
--------------------
"Why not the best?"
Jimmy Carter
 
guilio2010 (Electrical) (OP) 28 Jul 14 20:19

"No, not a typo. It took a fraction of a gas stream, moved a turbine (pressure drop) and combined it back to another gas stream of higher pressure"

Yes, definitely a typo, epete was right. Shall read "back to another gas stream of lower pressure" The diagram shows that it simply utilizes the pressure drop across the local pressure regulator to extract some energy that can be used to charge a battery.


Gunnar Englund
--------------------------------------
Half full - Half empty? I don't mind. It's what in it that counts.
 
I found a different Zeus charger when I Googled.

Bill
--------------------
"Why not the best?"
Jimmy Carter
 
I came across the TEG also when I googled it. I actually was searching to something else when I seen the logo and remembered it for a couple years ago so it happened to be luck that I found it.

 
Pressure drop across the regulator. I love a clever idea.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor