aafuni
Mechanical
- Dec 29, 2009
- 188
In my sketcher if I create a line, then try to create a curve tangent to it using the arc with tangent ends tool, the arc will not snap to the end of the line that is already there. I currently have to place an arbitrary arc then use both the coincident constraint and the tangent constraint in order to attach it to the line.
I have had this issue for years now, but only on one of my computers. An install on a second computer behaves as I would like, with the arc tool (or other sketcher tools) able to snap to the end of already created geometry. I have compared my config files and don't notice any differences that would cause this to happen.
Does anyone know where this setting is berried? It is probably right under my nose somewhere. Oh and I do have all the constraints currently enable in the sketcher options menu, and that does not help.
Thanks,
-AAFuni
I have had this issue for years now, but only on one of my computers. An install on a second computer behaves as I would like, with the arc tool (or other sketcher tools) able to snap to the end of already created geometry. I have compared my config files and don't notice any differences that would cause this to happen.
Does anyone know where this setting is berried? It is probably right under my nose somewhere. Oh and I do have all the constraints currently enable in the sketcher options menu, and that does not help.
Thanks,
-AAFuni