Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

SNK Machine model....

Thread starter wmFLIPPER
Start date Jul 19, 2010

Status: Not open for further replies.

Jul 19, 2010

wmFLIPPER

Mechanical

Hello everyone, I am looking for some solids or even iges files of a machine I have on the floor. Yes I have put in a request to the manufacturer and I may need it sooner. What I have is a "SNK 3 spindle 5-axis PM-6A gantry profiler". The drawings in the operation handbook just is not enough. So instead of taking a tape measure to most of the machine (which I have done some) this would be a lot easier and more accurate. Then all I would have to do is model in any coolant lines and such that hang down in the way.

Please point me in the right direction (if you do not have it). I need a faster response than a machine tool builder

Thanks in advance Phil.