Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Software recommendations for automatically generating fin and tube circuity?

Status
Not open for further replies.

MechEng92

Mechanical
May 12, 2015
61
Hi everyone,

Can anyone recommend some software that will automatically generate the circuit patterns for fin and tube heat exchangers, with a specified number of tubes tall, rows deep, and number of circuits? Ideally if air flow direction can be specified as well.

Thanks
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor