Harry Houdini
Aerospace
- Jan 22, 2021
- 18
Hello everyone,
I have a large assembly and I want to run an interference check on. The run time is fine and it completes in a few minutes. My question being, is there anyway (at the part level) to set a specific part as "ignored" so the interference detection does not pick it up. I am having an issue with 1000's of helical inserts being detected as an interference and I have to manually ignore their interference.
I realize that I could change how holes and the inserts are physically so they do not touch, but that would require and insane amount of work and may break references over thousands of assemblies.
Does anyone have any solutions? Thank you for your help!
I have a large assembly and I want to run an interference check on. The run time is fine and it completes in a few minutes. My question being, is there anyway (at the part level) to set a specific part as "ignored" so the interference detection does not pick it up. I am having an issue with 1000's of helical inserts being detected as an interference and I have to manually ignore their interference.
I realize that I could change how holes and the inserts are physically so they do not touch, but that would require and insane amount of work and may break references over thousands of assemblies.
Does anyone have any solutions? Thank you for your help!