Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Solution error estimation.
- Thread starter notekit
- Start date
SEPC should be 10% or less. SERR has units of energy (consequently, SEPC is derived from SERR) but requires you to look at the contours rather than the numerical values i.e. make sure that SERR contours are uniform. Notice that at stress singularities there is a sharp change in SERR. These and other parts of the mesh which show discontinuous contours are areas for mesh refinement.
-- drej --
-- drej --
- Thread starter
- #3
- Status
