Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SOS, Geometric Tolerances 1

Status
Not open for further replies.
chuny

chuny

Mechanical
Jul 22, 2005
6
CA
Good day, could you please tell me how to give the Geometric tolerances, which standard is good?I don't have any experience in this aera.

Thanks
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Hi Chuny,

ASME Y14.5M 1994 is the official spec. for your subject.
It is $125 USD new from ASME. There are older revisions and interpretations of same from $25 USD up.
 
Upvote 0 Downvote
Hi, CCW, thank you very much. I think it's better to buy older one.
Thanks again
 
Upvote 0 Downvote
VOLVO STANDARDS: STD 112-0003E, STD 112-0002, STD 112-0006,STD 5062,2E

Avaiable at just key in the standard number without the "STD" and save it to your hard disk.

These all are dealing with geometrical tolerances accoring to the ISO system but it is almost the same as the ANSI. Any way, as far as I know the coming new ANSI will be the same as the ISO.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

davidh729
  • Locked
  • Question
DIN 5480 Root and Tip diameter tolerances
Replies
3
Views
26
spigor
spigor
sabaa
  • Locked
  • Question
DIN tolerances for fine spur gear of module < 1 mm?
Replies
1
Views
7
spigor
spigor
Javy77
  • Locked
  • Question
Ansi 92.1 Spline, tolerances definition 2
Replies
5
Views
6
batter1979
batter1979
chuny
  • Locked
  • Question
about geometric tolerances
Replies
2
Views
3
ccw
ccw
wai36
  • Locked
  • Question
Tolerances
Replies
0
Views
2
wai36
wai36

Part and Inventory Search

Sponsor

Back
Top