special sweep

[helperug]

Can I do this in Nx:
I have profile I want to sweep along a guide, but the profile is not at the guide curve, a second guide spime control curve is avail. The profile should run at the guide....

sorry new in NX
regards
Erwin

 

[JohnRBaker]

Can you provide at least a picture of what you're attempting? Better yet would be an actual simply example file.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[jerry1423]

Is it possiblt to show a picture of what you are explaining?

 

[helperug]

here it is

sorry new in NX
regards
Erwin

 

[JohnRBaker]

It's still not clear exactly what it is that you're attempting to do.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[helperug]

the green face are the result, the profile without positioning should run/ guided at the blue face edges( Führung) the light blue face are given faces. In Nx I have to position/transform the profile at/to the guide, ... or is there a solution I don't know - Hope you'll understand.

sorry new in NX
regards
Erwin

 

[JohnRBaker]

OK, I think I uderstand now, and YES, the profile has to be positioned relative to the guide curve as you would like the profile to be swept. Note that it does NOT actually have to be positioned ON the guide curve, but it MUST be positioned so that when it is swept that it's 'part' of the surface that you desire.

I hope that's clear as to what I mean.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[Toost]

Our friend John isn't up to date here.
The (Amazing-) Styled Sweep feature can do the desired. See attached image.
( But it might not divide the new surface(s) as in your image. - It probably has to approximate the sweep. )

Regards,
Tomas

 

[helperug]

tankx tomas,
I have tried the styled sweep, but without success, I'm fighting the many options (to take care)


sorry new in NX
regards
Erwin