Nov 14, 2017 #1 iucu Mechanical Jun 5, 2003 31 I have a Spline/Curve, from point A to B. I want the Offset to be : 1 mm in A and 2 mm in B
Nov 14, 2017 Thread starter #2 iucu Mechanical Jun 5, 2003 31 sorry, in NX 9 , Sketch I want to do this Upvote 0 Downvote
Nov 14, 2017 #3 Toost Mechanical Jan 18, 2011 2,963 The sketcher cannot do this. The sketcher does not have variable offset. You can do this using a variable offset curve outside the sketcher. It will still be associative / parametric. Regards, Tomas Upvote 0 Downvote
The sketcher cannot do this. The sketcher does not have variable offset. You can do this using a variable offset curve outside the sketcher. It will still be associative / parametric. Regards, Tomas
