Split Body not working in NX11

[bongoman]

When I try to use split body in NX11.0.1.11 MP1 I get an error message "A deleted or invalid class id was used". Then nothing. Anyone run across this one? So far everything else seems OK.

Rick D

Win7 64 bit w/NX9.0.3.4 MP9 and NX10.0.3
Vericut 7.4

 

[JohnRBaker]

Try running 'Part Cleanup' on your model and then try again. If this doesn't help, contact GTAC.

John R. Baker, P.E. (ret)
EX-Product 'Evangelist'
Irvine, CA
Siemens PLM:
UG/NX Museum:

The secret of life is not finding someone to live with
It's finding someone you can't live without

 

[bongoman]

Thanks for the quick reply John. Good to hear from you. Unfortunately that didn't work so I will contact GTAC.

Win7 64 bit w/NX9.0.3.4 MP9 and NX10.0.3
Vericut 7.4

 

[MANox]

Hello,

I was have that same problem.
I was install nx 11 with "customize" option and Split Body did not work.
I was uninstalling NX and install with "typical" option and now this operation work.
I checked it at 3 diffrent machnines.

Best regards

Michał Nowak

 

[bongoman]

Hi Michal,

I ended up uninstalling and re-installing NX11 with "typical" as well but did not use "customize" the 1st time. It is working now. Contacted GTAC but they could not help me.

Regards,
Rick

Win7 64 bit w/NX10.0.3.5 MP14 and NX11.0.1.11 MP1
Vericut 8.0