Spreader beam in ANSYS 13, not workbench

[HankTheTank]

Hi, im making a 8x8 meter quadratic spreader beam that i was thinking of making in HUP profiles. It will hang from 4 steel wire connected to the corners. What element types should i choose in ANSYS 13?

Henrik

 

[nizzle1234]

For the wire you can use link180 elements. For the beams use beam188 or 189 either way it will give you the same solution.

 

[HankTheTank]

Thanks for the answer. It is much appreciated.
Do you also got any tips on where to put the displacement, i was thinking about ALL DOF in top of the wires, but i cant figure out where to put the one for the frame so it doesnt rotate.