Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Springs in Series Compression due to Acceleration

Status
Not open for further replies.

JCReynolds79

Automotive
Joined
Sep 6, 2007
Messages
115
Location
GB
Two springs in series w/different masses/rates. They are compressed some distance and "trapped" at this distance in a rigid frame. The springs' ends are attached to the inner walls of the frame. The frame is then accelerated in the axial direction of the springs.

How do I calculate how much the springs deflect?

Considering the springs are attached to the frame, one must stretch and one must compress and I believe it's the mass of the springs themselves that are going to drive things.

Thanks

Regards,

Jon Reynolds
 
Get a copy of (one of) Wahl's books, I have Mechanical Springs on my shelf. In there, Wahl gives a very good, detailed derivation of the dynamic equations of motion for helical springs. Treatment of the series springs is not covered (not clear why this is being done in your case, or what advantage is provided by two vs one spring) but is pretty straightforward. If one of the springs is much lower in spring constant than the other, you might be able to treat the heavier spring as a solid mass.
 
Hey btrueblood, thanks very much for the steer. Very useful info thanks.

Regards,

Jon Reynolds
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top