STAAD PRO P-Delta

[dimmm]

Hi guys.
May i know how to perform P-Delta analysis in STAAD PRO? Do i need to put values for Number of iteration and Converge boxes? I attached a picture.Please take a look and thanks for reading.

 

[SteelPE]

I believe you need to fill in at least one of the two boxes but you can put values in both locations. The analysis will run until the the drift is within a certain limit from one iteration to the next or the maximum number or iterations.

You may want to consult the program manual.

 

[dimmm]

Ok,thanks for your guidance.

Best regards.