BriWilWork
Mechanical
Is there an alternative to S7 tool steel (14 ga) that one can stamp / blank instead of forge?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Stamp / Blank Alternative to S7 Tool Steel 1
- Thread starter BriWilWork
- Start date
- Status
-
1
- #2
GregLocock
Automotive
Depends what properties you need from the finished part.If you are using it as ballast then yes, if you are using it for leaf springs, possibly, if you are using it to make pipe cutters then any good alternative will probably be just as tough to cut.
Cheers
Greg Locock
New here? Try reading these, they might help FAQ731-376
Cheers
Greg Locock
New here? Try reading these, they might help FAQ731-376
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question