Static dissipative plastic used for fixturing ESD sensitive components

[chopper75]

I would like to use a 3D printed tray to hold SMT components that are ESD sensitive. The 3D printed material has the following specs and I'm wondering if it will be safe to use:

Volume resistivity: 3.2 x 10exp11 ohm-cm
Surface Resistivity: 3.2 x 10exp11 ohm
dissipation Factor, 1 KHz: .177
Dielectric Constant, 1 KHz: 6.27
Dielectric Strength: 221kV/in

 

[IRstuff]

It looks like an insulator, compared to these:

http://www.achillesusa.com/wp-content/uploads/2012/10/Anti-static_Materials_Vol_11A.pdf

TTFN (ta ta for now)
I can do absolutely anything. I'm an expert!

https://www.youtube.com/watch?v=BKorP55Aqvg

faq731-376 forum1529 Entire Forum list

http://www.eng-tips.com/forumlist.cfm

 

[3DDave]

There are conductive paints that should work to prevent static buildup.