Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Stepper controller

Status
Not open for further replies.
sbkenn

sbkenn

Mechanical
Feb 22, 2010
64
Does anyone know of a device to interface analog temperature/pressure or other sensor, directly to a 2-phase stepper-type analog gauge ?

TIA
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Not off the top of my head. Sorry.
That would be covered by any 'industrial' stepper drive with a 4-20mA or -10V to 10V input. Just get out your wallet.

If you're handy a Gecko drive and an Arduino would do it.

Keith Cress
kcress -
 
Upvote 0 Downvote
I think I will just microstep a geared motor for more than 60degree gauge. Less than 60 degrees just use a fixed voltage on one coil, then analog voltage on the other.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

January Mahlalela
  • Locked
  • Question
HOW TO IMPLEMENT SELF-TUNING PID CONTROLLER?
Replies
3
Views
86
IRstuff
IRstuff
doehl1
  • Locked
  • Question
Dedicated Controller Supplier
Replies
7
Views
76
OperaHouse
OperaHouse
ibro10
  • Locked
  • Question
Speed control of stepper motor using phase locked loop
Replies
13
Views
156
VEBill
VEBill
jmeyer84
  • Locked
  • Question
Using a 5-wire resistive touch panel with a 4-wire controller?
Replies
0
Views
45
jmeyer84
jmeyer84
KRYM2006
  • Locked
  • Question
Do I need a galvanic decoupling between a controller and a power line? 2
Replies
9
Views
92
KRYM2006
KRYM2006

Part and Inventory Search

Sponsor

Back
Top Bottom