STP Export Error

[adam1986]

NX 8.5.3.3

When exporting STP files i get the following error:

step203ug.exe - Entry Point Not Found

I have tried STP203 and STP214, both fail to export with the same error
I have also tried other parts....

I can however export these parts on a different machine, so im assuming its a local error?
The only other issue i can see is that Virus scanners think its malware, so put it in isolation, but i doubt thats the case in this instance.

Thanks in Advance

Adam

 

[Toost]

I think you should call GTAC on this. It's either a poor install, or something that Gtac can help you sort out.

Regards,
Tomas