stress analysis after running returns nothing

[cgelang]

Hi,
Does anybody has experience this kind of problem during stress analysis?
Stress analysis will run/process but it will not return results(results is empty on the model tree). Is their a bug with my installation.
I'm using 2013 version. thanks for your ideas.
Regards,
cgelang

 

[btrueblood]

Seen it happen once before. Make sure the items you are analyzing are "enabled" and "visible" in the assembly/feature tree. Then try closing, restarting computer, and re-running analysis. Past that, good luck.

 

[rollupswx]

Did you have anti-virus and UAC turned off during install?
Can you attach a sample file here that exhibits this behavior?