Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

stress analysis after running returns nothing

Status
Not open for further replies.

cgelang

Mechanical
Sep 23, 2008
48
Hi,
Does anybody has experience this kind of problem during stress analysis?
Stress analysis will run/process but it will not return results(results is empty on the model tree). Is their a bug with my installation.
I'm using 2013 version. thanks for your ideas.
Regards,
cgelang
 
Replies continue below

Recommended for you

Seen it happen once before. Make sure the items you are analyzing are "enabled" and "visible" in the assembly/feature tree. Then try closing, restarting computer, and re-running analysis. Past that, good luck.
 
Did you have anti-virus and UAC turned off during install?
Can you attach a sample file here that exhibits this behavior?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor