Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Study sources on inspection and renovation 2

Status
Not open for further replies.

kaisersoze

Structural
Nov 10, 2008
49
I seem to be getting more and more involved in the renovation work that our firm is getting. Can anyone suggest some good books, artilces, websites to read up on basics of inspection and renovation specially concrete and masonry.

Thanks,

Kaiser
 
Replies continue below

Recommended for you

One book that I have found useful recently is "Structural Renovation of Buildings" by Alexander Newman.
 
Inspection is, in many respects, just the act of "looking". Knowing what to look for is, of course, critical. The "what" you will be looking for is primarily the design, so familiarity with design and the parameters of design will help you immensely. Unfortunately, you also have to be able to decipher designs that were done many years ago and attempt to discern the "intent" of the designer, as codes and standards were less clear in many respects than today's codes and standards.

Read codes...old and new. Read inspection manuals (ACI Manual of Concrete Inspection is a good start). Read treatises on condition assessment of existing structures (ASTM E2018 (Property Condition Assessment) and ASCE 11 ( Guideline for Structural Condition Assessment of Existing Buildings).
 
also areas of minor/major distress... and why... some latent problems have a slight manifestation... while others are completely hidden...

Dik
 
forgot to add... and knowing where you might find these problems, helps...

Dik
 
Watch a few detective shows.

I am only half kidding, inspections tend to be all about the detective work looking for the subtle signs of structural distress and covered up faults. There are some very goog UK publications by the IStructE but they would be of limited use to you.
 
I am not sure if the American Institute of Home Inspectors has anything - but you might check.

Search on Forensic Engineering - might get a few good hits there.
 
Check out ICRI.org. They have some good information. Also, if your area has a local chapter, get involved.
 
csd72 had a good point about the detective shows. I have good engineer friend that is great with finding the real problems and sources. - His hobby was watching and collecting "olde" Sherlock Holmes movies, which made everything elementary. It is a matter of observing and thinking about basic principles from a design and construction standpoint.

Dick



Engineer and international traveler interested in construction techniques, problems and proper design.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor