smcadman
Mechanical
- Nov 6, 2002
- 1,589
If you right-click a sub-assembly in a drawing and choose properties, on the "View Properties" tab there is an option to choose which display state you want to use. Wasn't there a similar option for choosing sub-assembly display states in top-level assemblies prior to SW06 SP4.1?
If I right-click a sub-assembly and choose "Component Properties", there is an option with configurations to "Use named configurations", and you can pick which configuration to use. I thought in SP3.0 there was also an option to choose display states also. Is my mind playing tricks on me, or was this option lost in SP4.1?
Flores
SW06 SP4.1
If I right-click a sub-assembly and choose "Component Properties", there is an option with configurations to "Use named configurations", and you can pick which configuration to use. I thought in SP3.0 there was also an option to choose display states also. Is my mind playing tricks on me, or was this option lost in SP4.1?
Flores
SW06 SP4.1