Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Suggestion for Square thread Stemnut of a non-rising stem gate valve

Status
Not open for further replies.

turbo05

Mechanical
Joined
Jun 20, 2005
Messages
6
Location
IN
Myself is currently working on a project to re-engineer a damaged stem nut for a non-rising stem gate valve. The thread on this valve is a nonstandard square thread with a diameter of 1.75 inches and a pitch of 3 threads per inch. I have not been able to locate any specific standards that might apply to this thread profile. I would be grateful for any guidance or suggestions from industry experts.
 
Thank you for your response.Not ACME, To clarify, I was referring to a square thread..
 
Find an 11th edition of Machinery's Handbook (1942), or earlier.

There should be square thread info.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top