Suppress by expression and unsuppress in UG Nx

[Gurusamuel]

Hello all,

In Ug Nx. I Couldn't able to unsuppress the feature which is already suppressed by expression.
for example.
Step-1
I was applied a radius in one edge of a block.
Step-2
That radius was suppressed by expression.
Step-3
I want to bring back the original feature. I used to make unsuppress the radius. But not suppressed.

Any one can help to me the Why the feature is not getting "Unsuppress" which is already suppressed by expression.

Thanks & Regards
GurusamuelT

 

[cowski]

You'll get a better response by posting this question in the UG/NX forum:
forum561

The short answer to your question is: you will need to change the value of the expression that controls the suppression or edit the feature so that the suppression is no longer controlled by an expression.

 

[Gurusamuel]

Dear Cowski,

Thanks for your reply's
Your correct. If we change the expression value that will control suppress and unsuppress. But I Need to remove all the relations from the history, there shouldn't be any expressions without getting any effect to the feature.
Thanks for your support and I posted the same query on Forum561:Siemens:UG/NX