bartbrejcha
New member
- Jul 1, 2013
- 23
Ill bet it's me but I get differing results when trying to make a surface extend in UG. Sometimes the surface extend gets dislocated and becomes disconnected. I would imagine there to be several settings there too.
1 strait extend with respect to an angle. G0
2 a G1 or tangental extend (where users can see tangent line)
3 a G2 or curvature extend (same surface no tangent line)
The other side worked fine
What can I do to extend a surface that has been swept along two or more tangent curves?
Bart brejcha training consultant
1 strait extend with respect to an angle. G0
2 a G1 or tangental extend (where users can see tangent line)
3 a G2 or curvature extend (same surface no tangent line)
The other side worked fine
What can I do to extend a surface that has been swept along two or more tangent curves?
Bart brejcha training consultant
