SW 2005 SP 4.0 Released 1

[EngJW]

Got mine installed, but where do you find out what the differences are? The only mention of it that I could find is only 4 paragraphs long, and there must be more to it than that.

 

[SBaugh]

Check the SP's at SW website. It will list what is fixed in SP4.0

Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376

 

[manxJim]

Had some strange issues with hatch patterns since upgrade
Example opened an existing drawing to find hatch pattern has changed angle in some views
Any one seen this??

 

[Regg]

I have not had that but hole callout quit working. Calls all holes and taps as geometry. Have not done a lot of investigation yet to see what the problem might else be.

 

[smcadman]

Yeah! You can now see the numbers for "spacing" and "number of instances" in the pattern of a PART in an ASSEMBLY. This problem has been brought up a couple of times, so I thought I would mention that they fixed it.

Flores