TC-NX5 assebly problem 1

[tadej001]

Hello!

I am working in NX trough TC 2007. When I make an assembly and loud in it some parts from TC that aren't mine(I'm not the owner). Than when I try to save the assembly, the following warning apear (Save warning->No attempt made to save the following parts, as they are read-only. if write access to any of these parts has been granted from PDM, use Tools->Teamcenter Integration->Lock/Unlock Parts-> Refresh locks Status to refresh (and below showing the part(s) that I load in the assebmly).

I not sure, but I'm thinking that in TC the rights of groups or users maybe aren't well defined.

If somebody know this error(warning), I appreciate the explenation.

Regards,
Tadej P.

 

[hudson888]

Posted it twice!

I have found that teamcentre is better is the better to use if you set up workflow to manage the ownership of files etc.

Cheers

Hudson

 

[tadej001]

Ok.... I was thinking that it is some cind of error...

thank you, for your advice...
tadej