Michel1978
Mechanical
Hello,
I'm trying to use the TDPwhich seams to be really nice but I have some issues with it.
Bill of Materials:
1. In the BOM I would like to add the material. But when I do so it says "The Material Attribute was reset because it did not match the material assignment. This action was taken based on your Customer Default setting." when I make the 3D-PDF.
2. It also does not take over a user made attribute.
3. I managed to add the mass attribute, but that is shown in grams, I would like to have it in kg.
I cannot find it in the help.
I am using NX1977.
Michel
Groeten, Michel
I use NX10 / NX1930
HP Z420 Intel Xeon 3.2GHz
Quadro K4000 3GB
32GB Memory
Windows 10, 64-bit
I'm trying to use the TDPwhich seams to be really nice but I have some issues with it.
Bill of Materials:
1. In the BOM I would like to add the material. But when I do so it says "The Material Attribute was reset because it did not match the material assignment. This action was taken based on your Customer Default setting." when I make the 3D-PDF.
2. It also does not take over a user made attribute.
3. I managed to add the mass attribute, but that is shown in grams, I would like to have it in kg.
I cannot find it in the help.
I am using NX1977.
Michel
Groeten, Michel
I use NX10 / NX1930
HP Z420 Intel Xeon 3.2GHz
Quadro K4000 3GB
32GB Memory
Windows 10, 64-bit
