Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tension only braces designing

Status
Not open for further replies.

canlv

Structural
Mar 25, 2022
1
Is it possible to design "tension only braces" to design in the software. I know that i need to perform non-linear analysis. But i tried to design and failed under this circumstances.
 
Replies continue below

Recommended for you

I use only one direction design with two models.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor