Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Test Separator for Produced Water

Status
Not open for further replies.
nickypaliwal

nickypaliwal

Materials
Joined
Aug 28, 2014
Messages
199
Location
OM
1) What are the typical material of construction for Test Separators ?

2) I have always observed Carbon Steel with Glass Flake Coating. Can there be any other coating as GRE lining ?

3) Is Glass flake coating is not susceptible to damage due to abrasion ?

 
Sort by date Sort by votes
Above query is for production fluid...
 
Upvote 0 Downvote
Its depends on composition and process parameters. We are using now Carbon steel+3mm CA with Phenolic Epoxy lining for separators.
we used CS+cladding also.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

rscosta1976
  • Locked
  • Question Question
Produced water oxygen ingress
Replies
4
Views
633
rscosta1976
rscosta1976
ShabsRBI
  • Locked
  • Question Question
Pump body for Sour Water Service
Replies
7
Views
2K
LittleInch
LittleInch
B
  • Question Question
Corrosion(?) on stainless at a waste water plant
Replies
9
Views
14K
Dhurjati Sen
Dhurjati Sen
awesomeness
  • Question Question
Effect of microstructure on crevice corrosion for SDSS
Replies
5
Views
17K
weldstan
weldstan
GetAtMeWolf
  • Locked
  • Question Question
Corrosion in High-Temp Hot Water Boiler System, specifically makeup water piping
Replies
6
Views
668
EdStainless
EdStainless

Part and Inventory Search

Sponsor

Back
Top