Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

thermal analysis, 20C/hr heat rate

Status
Not open for further replies.
adamjt

adamjt

Mechanical
Joined
Jun 13, 2005
Messages
10
Location
US
Is it possible to have a model of a pipe in Pro/Mechanica an apply a heat rate to it so that it heats up at 20C/hr. This is to find how much the temperature of the outside f the pipe lags the inside temp at certain heat rates.
 
Sort by date Sort by votes
If you set up a transient thermal analysis, it is not possible to vary a a prescribed temperature, but you can vary heat load or convection condition against time, so it might be possible to do your analysis.
 
Upvote 0 Downvote
Do you even need FEA for this? Heating up a pipe seems like you could find an analytical solution right out of a textbook.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

S
Dynamic Analysis of Theo Jansen walking mechanism
Replies
0
Views
37K
Sai Rakesh
S
Bobfromoh
  • Locked
  • Question Question
Thermal anaysis
Replies
1
Views
822
Bobfromoh
Bobfromoh
T
Angle analysis feature to be used as a dimension in a drawing table
Replies
1
Views
14K
annad_m_s
A
Bobfromoh
  • Locked
  • Question Question
Radiation heat transfer
Replies
0
Views
739
Bobfromoh
Bobfromoh
T
Slot-follower connection analysis
Replies
0
Views
7K
thanhhungone
T

Part and Inventory Search

Sponsor

Back
Top