Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Threads on an arc
- Thread starter jwalsh1
- Start date
lmcchesney
Mechanical
I did this once.
Create one thread using a helical sweep in a straight line tangent to the arc.
Rotate and copy that single thread about the centerline of the arc.
It's not geometrically correct, but it makes for a pretty good visual representation.
Create one thread using a helical sweep in a straight line tangent to the arc.
Rotate and copy that single thread about the centerline of the arc.
It's not geometrically correct, but it makes for a pretty good visual representation.
- Thread starter
- #3
- Status
Similar threads
- Question
- Locked
- Question