I searched and can not find the setting location to control the spacing in welding symbols to tighten up the vertical space between the symbol and the "grind flat" modifiers. The default spacing is very large. Does anyone know where to adjust this. See attached image for example.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Tighten up welding symbols
- Thread starter swale74
- Start date
JohnRBaker
Mechanical
Which version of NX are you running?
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #3
JohnRBaker
Mechanical
It appears that starting with NX 7.5, the spacing between the elements as shown in your sample image, have been reduced by about half.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Status
Similar threads
- Locked
- Question
- Locked
- Question