May 14, 2004 #1 fransancho Mechanical May 14, 2004 3 Is there a standard for Title Blocks? What information should be included and where should it be located on the drawing?
Is there a standard for Title Blocks? What information should be included and where should it be located on the drawing?
May 15, 2004 #2 looslib Mechanical Jul 9, 2001 4,205 ASME Y14.2, I think. But in actuality it is vague. It only gives you a rough space idea. We have a bunch of blocks that corportae says MUST be on the drawings. "Wildfires are dangerous, hard to control, and economically catastrophic." Ben Loosli CAD/CAM System Analyst Ingersoll-Rand Upvote 0 Downvote
ASME Y14.2, I think. But in actuality it is vague. It only gives you a rough space idea. We have a bunch of blocks that corportae says MUST be on the drawings. "Wildfires are dangerous, hard to control, and economically catastrophic." Ben Loosli CAD/CAM System Analyst Ingersoll-Rand
May 15, 2004 #3 TD2K Chemical Jan 11, 2002 2,629 If there is a standard, it's been tweaked for every job I've been on to some degree. Upvote 0 Downvote
May 17, 2004 #4 swertel Mechanical Dec 21, 2000 2,067 See this FAQ faq292-205 --Scott For some pleasure reading, try FAQ731-376 Upvote 0 Downvote
May 28, 2004 #5 rghay Mechanical Feb 25, 2003 48 It used to be covered in ANSI Y14.1 The last copy I had was 1980. Don't know if it has be updated, but would guess it has. Upvote 0 Downvote
It used to be covered in ANSI Y14.1 The last copy I had was 1980. Don't know if it has be updated, but would guess it has.
